All machine work is done in our new state of the art 12,000 square-foot facility seen here on our shop tour page. Call us today to discuss your special needs and we'll make sure your engine work is done with the highest attention to detail.
Block work:
Oven Clean, Shot Blast & Mag Block
$100
Bore & Hone Block with Torque Plate
$325
Deck V-8 Block
$150
Align Hone Main Line
Head Work:
Oven Clean, Shot Blast & Mag Heads
$40 Each
V-8 Three angle Valve Job, blend bowls
$225
Deck Head up to .010" cut
$75 each
Install New Guides V-8 Heads (16 guides)
$120
Back Cut 16 valves
$50
Bowl Port & Gasket match V-8 Heads
$350
Assemble v-8 heads and set up spring heights
$80
Rod Work:
Resize V-8 rods (per 8)
Install pistons on rods v-8 (8)
Crank Work:
Grind V-8 Crank
Balance V-8 Full Assembly
Assemble Short Block V-8 Engine
$400
Assemble Entire V-8 Engine
$600